 |
Halcyon 704A-410:
The Halcyon 704A-410 is a hand-held transmission with 25 kHz range and Network Access /
Signaling Test Functions with loop start, ground start, and DID test interface. |
 |
Sunrise T10:
The SunSet T10 provides one simple solution for all your T1 testing requirements. At two pounds, the SunSet T10 gives you the flexibility to bring this full testing capability wherever you need to go. Whether it is bi-directional monitoring, call emulation, or full-duplex drop and insert testing the SunSet T10 verifies operation and troubleshoots line signaling and protocol problems. It provides a flexible and easy solution for digital trunk testing. It provides a full report for each channel: including pass/fail, BERT results on data calls, and cause values for any failed calls.
Options Include:
C: SW185 - MF/DTMF/DP
D: SW183 - Noise Analysis
E: SW189A - SS#7 Analysis
G: SS151 - Datacom Module
H: Datacom Mode
L: SW181 - CSU/NI Emulation
T: T1 Low Level Measurement
U: New Keypad Scanning |
 |
Sunrise T3:
Frequency
Noise
C-Message Noise
C-Notched Noise
Signal to Noise
T3 and Dual T1 |
 |
Halcyon 701A:
The 701A Transmission Test Set measures transmission level, frequency and noise (including notch noise) on voice- grade, and program circuits up to 20kHz in bandwidth. Has dual digital display, crystal-controlled 1004Hz holding tone and can be manually adjusted to provide tones over a 50Hz to 20kHz frequency range. Rechargeable batteries provide the 701A with six hours of normal operating time. |
 |
HALCYON 756A DDS Test Set: The 756A Integrated Digital Data Services (DDS) Test Set is designed to accommodate complete 4-Wire DEMARC and DS0/DDS testing functions in a single hand-held, light weight test set package. The unit provides DDS BERT, DSU/CSU simulation functions, latching and alternating loop code commands, control codes at 4W DEMARC as well as DS0 and OCU data-port plug-in modules, and load coil detection.
[ADD TO CART] |
 |
TCI 420
The TCI 420 Cable kit is used to support Dual DS1 (T1) and DS3 (T3) in a easy to use kit.
Includes:
4 Bantam to Bantam 6’ Test Cords
2 Bantam to Alligator Clip 6’Test Cords
2 RJ45 to Dual Bantam (Y configuration) 6’ Test Cords
1 Cat5 Cable 1 RJ45 Break Out Box
Carry CaseCOST $ 395.00 |
 |
TCI 440
The TCI 440 is used to support Dual DS DS1 (T1) and DS3 (T3) and test sets with a Optical Interface.
Includes:
4 Bantam to Bantam 6’ Test Cords
2 Bantam to Alligator Clip 6’Test Cords
2 RJ45 to Dual Bantam (Y configuration) 6’ Test Cords
1 Cat5 Cable 1 RJ45 Break Out Box
Optical ST to ST Patch Cords
SC to SC Patch Cord
LC to FC Patch Cord
ST to FC Patch Cord
FC to FC Patch Cord
Carry CaseCOST $795.00 |
 |
TCI INSTALLERS BUCKET
Includes:
Lineman’s Butt Set
DVM,66 Punch Down Tool
Tone Tester
60 piece set of Super Deluxe Tool kit
COST $995.00 |
