Timing

CXR/LARUS NETWORK TIMING & PROTECTION SWITCHING

http://www.cxrlarus.com/products/NextGenTimingProducts/index.htm

http://www.cxrlarus.com/products/TransmissionProducts/APS/index.htm

GUISYS INTELLIGENT TIMING ANALYSIS SYSTEM

http://www.guisys.com/TimingTest.html

Add Ports to ANY Network Timing/Synchronization System

Is your Network Timing/Synchronization system 100% full up? Need more output ports but the manufacturer is holding you up for ransom? Need to squeeze more time out of the existing system without total replacement?

At up to 60% savings over incumbent products, the TiemPo 6400 can add Timing & Synchronization ports to ANY legacy timing system, regardless of brand or vintage. The TiemPo 6400 may be configured as a full PRS/BITS clock or a distribution-only shelf featuring port-selectable outputs for T1/E1, CC or 2.048MHz.

To add ports to any existing system, merely connect (transfer) two T1 or CC outputs from the legacy system to the input ports on a TiemPo 6400 (will work with 1 T1 or CC, but fully redundant with 2 inputs). These inputs will “drive” the TiemPo shelf with the same Stratum level as provided by the legacy shelf, including SSM messages if provided.

At only two rack units (2RU), TiemPo offers up to 8 output card slots with 8 outputs per card. TiemPo 6400 allows each output port to be set independently, requiring fewer output cards per output type. Competing systems force you to equip cards so that all ports are the same, stranding unused ports and allowing them to sell you more cards.

TiemPo 6400 offers SNMP management over Ethernet connections, and will function perfectly with any brand or vintage Timing System.

Add as many TiemPo 6400 shelves as needed and over time, transfer outputs from the legacy system as cards begin to fail. Once most outputs have been cutover to TiemPo, you may install GPS receivers and oscillators for a complete Stratum 1 timing system.

Replace your Timing System on YOUR timetable, not theirs.